Peripheral-electronics iPod2car Manual de usuario descargar pdf (Pagina 12)

TOP VIEW

1 2

DIP

DIN CONNECTOR / DIP SWITCH VIEW

22-PIN HARNESS VIEW

1.6 Programming the

iPod2car

Now that you have identiﬁ ed the correct harness and dip-switch conﬁ guration us-

ing the application guide, it is now time to program the interface.

To program the interface, set the dip-switches located on the side of the interface

(see Fig.1 below) to the congﬁ guration listed for your vehicle in the Application

guide.

Switches are in their default setting of “off” in the up position and are turned

“on” when switched down.

Refer to the chart on the bottom of this page.

This programs the iPod2car to the vehicle it is being installed in. The dip-switch-

es MUST be set before the interface is plugged into the vehicle. Otherwise the

iPod2car will not work correctly.

Dip Switch Conﬁ guration Chart

Fig.1 Side view of Interface with dip switches

Conﬁ g. #1

off

Conﬁ g. #

off

Conﬁ g. #

off

Conﬁ g. #

off

Conﬁ g. #

off

Conﬁ g. #

off

Conﬁ g. #

off

Conﬁ g. #

off

Conﬁ g. #

off

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Peripheral-electronics iPod2car Manual de usuario Pagina 12