
2.1 Installation Location
Most installations will require you to remove the factory radio in order to plug in the vehicle
specifi c harness. Some vehicles may require you to connect the interface to a factory pre-
run CD changer cable. The location of these CD changer cables will vary by vehicle. Some
common locations of these cables are in the trunk, behind the glove box, and in or under a
2.2 Pre-Installation Checklist
beginning the installation:
• Your iPod’s Firmware should have been updated. (section 1.2)
• You should have your radio’s security code.
(when applicable, see section 1.2)
The dip-switches on the interface should have been set with the proper confi guration.
• You should have in your possession the correct harness for your vehicle. (
• You have determined your installation location.
these steps has not been taken, STOP. Only when ALL of these steps have been
taken should you proceed with the rest of the installation.
Common Connection Locations
MENU
SEEK
SCAN
RDS
VOL
PWR
TUNE
DSP
BAND
TAPE
DISC
INFO
TRAF
SEEK
TYPE
AUTO
EQ
AUTO
VOI
3 41 2
5 6
Refer to Application Guide
Chapter 2- General Installation
Some vehicle specifi c harnesses require wiring connections that involve splicing of wires. If
you are not confi dent in making these connections to your radio’s wiring harness, we recom-
mend you seek professional installation. You can visit www.iPod2car.com and click on the
dealer link at the top of the page to fi nd an authorized professional installer.
Comentarios a estos manuales